Specifications

Technical Procedure Quiz 17730–248
A-112
25) Prior to performing a total vehicle alignment the following components must be inspected.
a) Front and rear spring mounts
b) Steer axle tires
c) Ride height
d) All of the above
26) When the clamp group is disassembled the use of a cutting torch is acceptable to help
remove seized bolts and nuts.
True or False
27) Prior to steering knuckle re-assembly it is critical that residual Loctite be removed and re-
applied from the upper kingpin connection.
True or False
28) AIRTEK is available exclusively with the STEERTEK axle.
True or False
29) To heat test a shock absorber you should drive a vehicle at moderate speeds for fifteen
minutes.
True or False
30) If the kingpin bushing is worn, then both bushings on that knuckle need to be replaced.
True or False
31) The unique packaging of the steering knuckle will allow up to ______ degrees of wheel cut
on the STEERTEK axle.
a) Maximum of 50°
b) 32°
c) 87°
d) None of the above
32) A pre-alignment inspection reveals a tie rod end is worn out of specification. What is the
correct action needed to complete the alignment.
a) Fill the tie rod with grease to absorb excessive play
b) Replace the tie rod and reset toe before alignment
c) Perform alignment and then replace tie rod end and reset toe
d) Align vehicle and do not repair tie rod end
33) The seal on the thrust bearings are installed facing down.
a) True
b) False
c) Doesn’t matter
34) When servicing tie rod ends it is not necessary to have the part number located on the tie
rod tube to order tie rod service kits.
True or False
CERTIFICATE Hendrickson will provide a personalized AIRTEK/SOFTEK Technical Procedure Quiz
Achievement Certificate to candidates scoring 80% or higher on the test. Simply
complete the test and fill in the enclosed answer sheet or on a separate sheet with the
return address, name, phone number, and company name as it will appear on the
award to:
Hendrickson
ATTN: Truck Marketing Test Quiz Assessment
800 S. Frontage Road
Woodridge, Illinois 60517
L
154
1
APPENDIX
SERVICE MANUAL