User manual

1. Important safety instruction
Do not turn on/off the unit constantly by
pulling out/inserting in the plug.
It may cause outlet damage or electric shock
or fire.
Do not operate the unit with wet hands.
It may cause electric shock or damaging the unit.
Do not put spray canister near air outlet
(within 1M) since the warm wind could cause
the spray canister explode.
Do not put a pet or house plant where will be
exposed to direct air flow. This could injure the pet
or plant.
The plug should be inserted completely.
Remove dirt from the power plug and
securely insert into the outlet.
If dirt adheres to the plug or insertion is
incomplete, it may cause a fire or electric
shock.
Do not clean the unit directly with water
It may cause an electric shock and other troubles.
Do not install the unit by yourself. Incorrect
install may cause leakage, electric shock or a
fire.
It should be installed by your dealer or similar
qualified person.
Do not put anything on the unit or do not step on it.
It may cause an injury through dropping and falling
down.
Do not install the unit where flammable gas
could leak. If gas leaks and collects around
the unit, it may cause an explosion and a fire.
Do not pull the power cord.
Hold the power plug to disconnect it.
The core wire of the power cord may be
disconnected and it may cause a fire.
When the unit needs to be cleared, switch off
or turn off the breaker, since the fan rotate at
high speed may cause injury.
Do not put any electric appliances under the unit.
The dropping water may cause eroding or some
trouble or electric shock.
When the unit is not going to used for a long
time, disconnect the power plug or turn off the
breaker.
When an abnormality (smell of burning)occurs,
stop the unit and disconnect the power plug or
turn off the breaker. Since it may cause trouble or
electric shock or a fire, etc.
Please consult your dealer or technique service
center.
Apply grounding
Do not connect a grounding wire to a gas
pipe, water pipe, lightning rod or ground wire
of a telephone.
If a grounding is incorrect, it may cause and
electric shock.
Do not move the unit by yourself. If the installation
is incorrect, it may cause some trouble or water
escaping or electric shock or a fire.
Please consult your dealer or technique service
center.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
Do not repair the unit by yourself. if this is done
incorrectly, it may cause a fire or electric shock.
Please consult your dealer or technique service
center.
The appliance shall be installed in
accordance with national wiring regulation.
2