1. Configuring MESH: Installing the first Air 4920 © INTERNET YOUR MODEM Connect the Air 4920 to Internet gateway via Ethernet Cable (1) and electric power (2) as show above and power it up by pressing the power button (3). Wait for about two (2) minutes for the all of the LED turn solid: + Power: Should turn solid WHITE as soon as the Air 4820 is powered on. ® 2.4GHz: Should turn solid GREEN in about one (1) minute. + GHz: Should turn solid GREEN in two (2) minutes.
2. Configuring MESH: Expanding the MESH network internet Existing MESH network This section must be repeated for each Air 4320 to be added to the MESH network. Place the additional Air 4920 near an Air 4920 that is already set up. There should be at least one Air 4320 previously set up {if not, then complete Section 1, “Configuring MESH: Install the first Air 49207). Connect the additional Alr 4920 © to electric prows (1) and power it up by pressing the power button (2) as shown left.
Once all three LED on the front of the new Air 4920 turn solid colors, proceed with adding ditto the MESH network: » Push the WPS button for 2 seconds on an Air 4920s that is already on the MESH network and that has a solid GREEN GHz LED, Please note that the Air 4920 chosen for this step could be the first Air 4920 that was set up, ie. the one that is wired to the modem (see Section 1). Or, 1t can be an Air 4920 that was later added to extend the MESH network.
4, Appendix B: Customizing WiFi Settings Connect your WiFi client (e.g. laptop or tablet) to the factory-default ELAN Name (SAID) on using the factory-default ELAN Password, « Open a web browser and type “aird820.local” in the address bar. + Login credentials: Username: admin ~ Password: Click “Quick Setup” on the left navigation menu.
Access Point tab will be enabled as the active tab. + Configure required settings by clicking on ELAN 1 (2.4 GHz) or ELAN 2 (5 GHz) tabs, SAID and Security settings can be accessed by scrolling the web page.
5. Appendix C: Status LED and Simple Troubleshooting Steps LED indicators: | LED LED Behavior Explanation Troubleshooting Step e) Hack tha power button on tha back Gt Dark o Power OFF must be pressed in). white [Solid Power ON No action recurred Power (Single color, [White |Blinking Firmware upgrade In progress [No action required white) Power the uri oft, welt for 10 seconds, i. . and then power it back on. failure Red Blinking He Failure® condition stratum, seal help from technical support.
