User Guide

5.8Ghz low power radar sensor
Radar sensor
Version 1.0
Page
10
7. Label and compliance information
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user
’
s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
‐ Consult the dealer or an experienced radio/TV technician for help.
The system integrator must place an exterior label on the outside of the final product housing
the AT58L4MD-2020 Modules. Below is the content that must be included on this label.
The host product Labeling Requirements:
NOTICE: The host product must make sure that FCC labeling requirements are met. This
includes clearly visible exterior label on the outside of the final product housing that displays
the contents shown in below:
Contains FCC ID: 2AVK2-AT58L4MD-2020
8 .Information on test modes and additional testing requirements:
When testing host product, the host manufacture should follow FCC KDB Publication
996369 D04 Module Integration Guide for testing the host products. The host manufacturer
may operate their product during the measurements. In setting up the configurations, if the
pairing and call box options for testing does not work, then the host product manufacturer
should coordinate with the module manufacturer for access to test mode software.
9. Additional testing, Part 15 Subpart B disclaimer:
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.249)
list on the grant, and that the host product manufacturer is responsible for compliance to any
other FCC rules that apply to the host not covered by the modular transmitter grant of
certification. The final host product still requires Part 15 Subpart B compliance testing with
the modular transmitter installed when contains digital circuity.