User's Manual

M033103V10
2
STATEMENT FOR MODUAL APPROVAL
This product is sold to OEM integrators only. The manual for the OEM integrators must include some instructions
that must be followed by the end users in the user manual. For example:
- The OEM integrators must be instructed to ensure that the end user has no manual instructions to remove or
install the device.
- The OEM integrators must be instructed about the end product labeling ("Contains TX FCC ID: QDWWM168B")
etc.
Please add the following statements to the manuals for the OEM integrators:
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator
is still responsible for testing their end product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID
cannot be used on the final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm
may be maintained between the antenna and users (for example, access points, routers, wireless ADSL modems,
and similar equipment). The final end product must be labeled in a visible area with the following: "Contains TX
FCC ID: QDWWM168B".
Manual Information for End Users
The end user must not have manual instructions to remove or install the device.
The user manual for end users must include the following information in a prominent location.
“IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, this grant is applicable to
only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.