User's Manual

8
Figure 2.2-4: The Wireless Network Connection Properties Dialog Box
c) Click OK. Now, you have successfully disabled the Wireless Zero Configuration.
To monitor and configure the network via WLAN-54G USB Configuration Tool, double-click its
tray icon, and you shall find seven tabs contained in the popped up configuration interface this
time. For more information on WLAN-54G USB Configuration Tool, please refer to the chapter:
WLAN-54G USB Configuration Tool Basics
below.
Note: If you wish to configure networks through Windows XP’s built-in configuration tools – Wireless Zero
Configuration, please refer to the Windows XP Wireless Zero Configuration Tool chapter.
2.3 Verifying a Successful Installation
To confirm that the Wireless 802.11g/b USB Module is properly installed, please follow the
procedures below:
1. Right-click My Computer desktop icon and choose Properties from the opened menu.
2. In the System Properties dialog box, select the Hardware Device tab, and then click
the Device Manager button.
3. In the opened window, expand Network adapters to find the USB Module – WLAN
IEEE802.11g/b Wireless LAN USB Adapter. Right-click over the item and choose
Properties.
4. Select the General tab from opened dialog box, find the descriptions under the Device
Status pane to check if the USB Module is working properly. However, if there’s an error
message such as a red or yellow icon attached aside, please uninstall the module,
restart your system and go through the installation procedures again. (About uninstalling