User's Manual

STATEMENT FOR MODUAL APPROVAL
This product is sold to OEM integrators only. The manual for the OEM integrators must include some
instructions to be followed by the end users in the user manual. For example:
The OEM integrators must be instructed to ensure that the end user has no manual instructions to
remove or install the device.
The OEM integrators must be instructed about the end product labeling ("Contains TX FCC ID:
QDWWM168GI")
etc.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users (for example, access points, routers,
wireless ADSL modems, and similar equipment). The final end product must be labeled in a visible
area with the following: "Contains TX FCC ID: QDWWM168GI".
Manual Information for End Users
The end user must not have manual instructions to remove or install the device.
The user manual for end users must include the following information in a prominent location.
“IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile
Configurations.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.