User's Manual

Use WEP Key

Indicate which WEP key you intend to apply to activate the WEP encryption from the pull-down

menu. Make sure that the intended access point on the wireless network shares the same keys.

By default, Key 1 will be used.

Create Keys with Passphrase

Choose this command when the associated wireless network uses a passphrase to create WEP

keys. Enter the passphrase string in the Passphrase filed to generate four encryption keys in the

Key fields above. Note that only letters A-F are valid for the Passphrase feature.

Note: When entering the passphrase here, ensure that you have specified an accurate type of the

Encryption (WEP security) above according to the associated agent’s configuration. Otherwise, the

inaccuracy will cause failure of performance.

After finish configuring the Encryption features, remember to click Apply to initiate the new

settings.

The Site Survey Tab

First of all, while entering this tab, please do choose the Rescan button to reinitiate the scanning

process and update the list. Later the result of scanning will be renewed and displayed. From the

offered information, you may learn the general information on the status of current scan lines,

including BSSID, SSID, signal strength, the channel number, WEP type, and network type.

In addition, to directly make an association with any site on the list, double-click the BSSID field of

the intended entry, and you will be led to the Status tab then.

Figure 3.3-5: The Site Survey Tab

The IBSS Tab

If you are communicating with other stations via the IBSS (802.11 Ad-hoc mode) to form

peer-to-peer networks, click the IBSS (Independent Basic Service Set) tab to specify an operating

radio frequency channel from the pull-down list under the IBSS Channel Selection field.