User's Manual

- 2 -

802.11b WLAN CF Card

For OEM Installation Guide

STATEMENT FOR MODUAL APPROVAL

This product is sold to OEM integrators only. The manual for the OEM integrators

must include some instructions to be followed by the end users in the user manual.

For example:

- The OEM integrators must be instructed to ensure that the end user has no

manual instructions to remove or install the device.

- The OEM integrators must be instructed about the end product labeling

("Contains TX FCC ID: QDWWN500").

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the

antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or

antenna.

As long as the 2 conditions above are met, further transmitter test will not be

required. However, the OEM integrator is still responsible for testing their end

product for any additional compliance requirements required with this module

installed (for example, digital device emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions cannot be met (for example

certain laptop configurations or co-location with another transmitter), then the FCC

authorization is no longer considered valid and the FCC ID cannot be used on the

final product. In these circumstances, the OEM integrator will be responsible for

re-evaluating the end product (including the transmitter) and obtaining a separate

FCC authorization.

End Product Labeling

This transmitter module is authorized only for use in device where the antenna

may be installed such that 20 cm may be maintained between the antenna and

users (for example, access points, routers, wireless ADSL modems, and similar

equipment). The final end product must be labeled in a visible area with the

following: "Contains TX FCC ID: QDWWN500".

Manual Information for End Users

The end user must not have manual instructions to remove or install the device.

The user manual for end users must include the following information in a

prominent location.

This device cannot be used with handheld PDAs (personal digital assistants) or

portable

radio equipment.