User's Manual

- 6 -
The 802.11b WLAN CF Card aims to let your computer quickly and seamlessly
communicate with 802.11b (at up to 11 Mbps) networks . Wireless LAN is local area
networking without wires, which uses radio frequencies to transmit and receive data
between PC’ s or other network devices. Additionally, wireless LAN is able to configure
either independent networks , which is also known as peer-to-peer or ad-hoc network, or
infrastructure networks . The former is suitable for small or temporary peer-to-peer
configurations, and the later is offering fully distributed data connectivity via micro cells and
roaming.
Wired Network
Ad-Hoc Network Configuration
Access Point
Infrastructure Network Configuration
Printer
Internet
Please refer to the proper section below corresponding with operating system you are using
to install the 802.11b WLAN CF Card and the attached PRISM Configuration Utility.
Installation Procedures for Windows 98 Users:
1. Insert the supplied Setup CD into your CD-ROM drive, the Setup Wizard will run
automatically. If it does not, please manually execute setup.exe.
2. The PRISM Driver for Windows –Welcome dialog box will be prompted. Click Finish
to continue.
3. Click Next in the Welcome dialog box to proceed.
4. In the Software License Agreement dialog box, choose Yes to accept the agreement.
5. Click Finish in the prompted Setup Complete dialog box.
6. Restart your computer then.
7. After rebooting, plug the 802.11b WLAN CF Card into your PC’s CF slot. Windows will
automatically detect the input device and display the New Hardware Found message
box. At the same time, you will be asked to insert the Windows 98 CD-ROM, please do
so and click OK to proceed.
8. In the Copying Files dialog box, click Browse to indicate Windows to install the
appropriate file from the folder named WIN98 on the CD-ROM, and then click OK. In a
few seconds, the installation is entirely complete.
Installation Procedures for Windows 98SE/Me Users:
The installation under Windows Me is very similar to that under Windows 98SE. Please go
through the instructions below if you are using Windows Me or Window 98 SE.
1. Insert the supplied Setup CD into your CD-ROM drive, the Setup Wizard will run
automatically. If it does not, please manually execute setup.exe.
2. The PRISM Driver for Windows –Welcome dialog box will be prompted. Click Finish
to continue.