User's Manual
AW 96 Series System Installation Manual
___________________________________________________________________________
AirWalk Proprietary and Confidential Page 24 of 56 6/14/2006
6 AW 96 / AW 10 Interface Cabling
6.1 RF Cabling – AW 96 MiniCell
The AW 96 MiniCell Antenna ports are connected to the external diversity antenna
systems as shown in Figure 6.1 (cables not included). External connectors are SMA type.
In a non-diversity application, connect the antenna system to the main antenna port. Note
the internal duplexer function provides a duplexed TX/Rx connection at the main antenna
port (marked Txα on some enclosures).
Antenna systems must include suitable protection against lightning and other hazards in
accordance with conventional cell site installation practices.
Figure 6-1 AW 96 MiniCell RF Cabling Diagram
6.2 RF Cabling – AW 10 Pilot Beacon
The AW 10 Pilot Beacon Antenna port is connected to the external antenna system as
shown in Figure 6.2 (cables not included). External connector is SMA type.
The AW 10 Pilot Beacon is not equipped with any receivers, therefore there is no
duplexer requirement for normal operation. Note the main antenna port may be marked
Txα on some enclosures.
Antenna systems must include suitable protection against lightning and other hazards in
accordance with conventional cell site installation practices.
GPSANT
RF RXA(a)
RF TX
(a)
RF TX(b)
RF RXB(r) RF RXA(r) RF TX (r)
T_EVEN
T_10MHz
RU IF BSC IF
ENV IF BTS IF
RF RXB(a)
RF RXB(b) RF RXA(b)
GPSANT
RF RXA(a)
RF TX
(a)
RF TX(b)
RF RXB(r) RF RXA(r) RF TX (r)
T_EVEN
T_10MHz
RU IF BSC IF
ENV IF BTS IF
RF RXB(a)
RF RXB(b) RF RXA(b)
To Main
Antenna
To Diversity
Antenna