Installation Guide

EdgePoint PRO Installation Guide
______________________________________________________________________________
AirWalk Proprietary and Confidential Page 11 of 19
• For optimal performance of the device, a back haul bandwidth of 5 Mbits should be
reserved for each device.
• For cluster configuration, each device within the cluster needs its own linear back
haul bandwidth. All the devices within a cluster require the same back haul network
for optimal performance.
Static IP Addressing Scheme
The eFemto supports static IP addressing for the device. The device is shipped from the
factory using DHCP IP addressing scheme. The USB cable provided should be used to set
static IP address for the device (see EdgePoint PRO - USB Console User Guide for more
information).
When using static IP address for the device, along with the IP address, the Subnet Mask,
default Gateway and DNS server information should also be provided to the device using the
USB connection.
4.3 Hardware Configuration
The eFemto offers a unique combination of 1xRTT and EV-DO radio and controller in one
physical platform that is differentiated from other systems. The eFemto comes equipped
with a Network Listener module which aids the device in sniffing its RF environment to
reduce interference to existing Macro networks. The device also has an in-built GPS receiver
which is used to validate the position of the device once it becomes operational.
The following table lists the eFemto device specifications:
EdgePoint PRO Specifications
RADIO
Technology
CDMA 1xRTT and 1xEV-DO Rev. A
Frequency Bands
1900 MHz
Simultaneous Calls
Up to 29 simultaneous voice calls
Up to 32 active data sessions
Transmit Power
200 mW
Configuration
1 carrier / omni
CONTROLLER
Handoff
Soft / hard
Integrated
BTS, BSC, RN, RNC, PCF and O&M
INTERFACES
Core Network Interface
SIP/IMS
RTP/MGW
PDSN
IP-10/100 Base T Ethernet – (A10,
A11)
AAA+HA
IP-10/100 Base T Ethernet – (A12)
SeGW
IKEv2
POWER SUPPLY AC
15 amps maximum / 120V AC
ENVIRONMENTAL
Temperature
Operating 0°C to 50°C (32°F to
122°F)
Humidity
0 to 95% non-condensing
HARDWARE
Installation
Wall mount
Dimensions (HxWxD)
12” x 14.6” x 2”