Installation Guide

EdgePoint PRO Installation Guide
______________________________________________________________________________
AirWalk Proprietary and Confidential Page 15 of 19
5.3 Mount Bracket to Wall
Once the location has been selected, mount the bracket to the wall.
1. Mount eFemto at least 6ft (2m) from floor
¾ Do not mount above ceiling or on ceiling
2. Use mounting bracket as a template to determine hole positioning and level the
bracket
3. Drill 3 wall anchors into the wall, if necessary. If mounting to a beam, no wall
anchors will be necessary.
4. Position the bracket lined up with the holes
5. Drive screws through the bracket to firmly secure it to the wall
Figure 5 - Mounting Bracket Installation
5.4 Position Power Supply, Cables and Antennas
Use the mounted bracket as a base support to:
1. Place power supply into designated location at top of bracket
2. Use side areas of bracket to roll excess cable slack and tie wrap access cable into
position
3. In the right cable guide space, pull power cable through to secure to device with
approximately 2” of clearance
4. In middle space, place Ethernet cable through the cable guide with approximately
2”of clearance
5. In the left space, place GPS antenna cable through the cable guide with
approximately 2”of clearance
6. Install the GPS antenna within 15 ft (5m) of a window with no metal sheeting and
with an open view of the sky