User's Manual

AW100 Series System Installation Manual
____________________________________________________________________________
_____________________________________________________________________________
AirWalk Proprietary and Confidential Page 35 of 54
AW100- 1xEV-DO
The following menu driven commands permit local changes of the FA.
Step 1
At the prompt enter the following:
> mpt32a
// this will take you to the menu screen similar to below:
================================================
1. Transmitter Test
2. Receiver Test
3. Parameter Setup
4. RF Gain Display
5. XCVR Setup
6. Turn Debug Messages On
7. Turn Debug Messages Off
0. Exit
================================================
Select Number ===>
Step 2
Enter the following
Select Number ==> 5
// this will take you to the below menu screen.
===================== XCVR SETUP ====================
1. Set Channel
2. Set TX On
3. Set TX Off
4. Set Att. Gain
5. Set Reset Reason
-----------------------------------------------------
6. Show Channel
7. Show XCVR Model ID
8. Show Att. Gain
9. Show RSSI1