User's Manual

AW100 Series System Installation Manual
____________________________________________________________________________
_____________________________________________________________________________
AirWalk Proprietary and Confidential Page 44 of 54
7.3.1 Web Server Installation Tool Set-up
The Web Server Installation Tool is built into the IP-RAN base station. Connection to the
tool requires only a PC equipped with an Ethernet capability and a common browser such
as Explorer.
Connection from the PC to the base station is made over the local Ethernet connection at
the cell site, usually via the local on site Ethernet switch (Figure 7-1).
Refer to the Web Server Installation Tool document for complete instructions on
configuring the PC and browser to access the web server tool. Abbreviated instructions
are provided in the remainder of this section for users previously familiar with the Web
Server Tool.
Figure 7-1 Initial Configuration Using Local Web Server
7.3.2 Web Server Connections
There are some rules that should be followed when making the parameter changes.
Some of the parameters have to be used with a valid IP address format such as
“xxx.xxx.xxx.xxx”, where xxx is a digit between 0 to 255.
The parameters that are important for the configuration of the AW100 are Primary IP
Address, Subnet Mask, Host IP Address, and Gateway. In addition BSID, Base Station
ID, should be composed of number between 0 to 4095. The value of 5000 is a special