User's Manual

AW100 Series System Installation Manual
____________________________________________________________________________
_____________________________________________________________________________
AirWalk Proprietary and Confidential Page 49 of 54
- Completion of the installation checklist
- Final approval by the relevant customer authority
7.5 Recommended Installation Tools and Supplies
1) Hand Tools:
a) Screwdriver set
b) Pliers set
c) Nut Driver set
d) Cutter set
e) Punch Down tool, or wire-wrap tool (site dependent)
f) RJ-45 crimper tool
2) Test Equipment:
a) Multi-meter and adapter kit
b) PC equipped with Ethernet card and browser
c) RF test set (power measurement, or optionally a CDMA test set)
d) RF adapters
3) Supplies:
a) RJ-45 connectors
b) Cat 5 or 6 Cable
c) Cable tie-wraps
d) Rack mounting screws and related rack hardware
7.6 Troubleshooting Procedures
The AW-100 Series CDMA IP-RAN system is designed to provide reliable and consistent
high performance in all network environments. The installation procedure described in
this manual for the IP-RAN is quite straightforward and simple to implement.
Should problems develop during installation, this section is intended to help locate,
identify, and correct these types of problems. Please follow the suggestions listed in the
following sections prior to contacting the AirWalk Customer Support Center. If you are
unsure of the procedures described in this section, contact the installation coordinator
immediately for clarification.
7.6.1 Before Calling for Assistance
1) If difficulty is encountered with a specific component of the IP-RAN, refer back to the
Installation Section for that component.
2) Check the cables and connectors to ensure that they have been properly connected
and the cables/wires have not been crimped or impaired in some way during
installation.