User's Manual
AW100 Series System Installation Manual
____________________________________________________________________________
_____________________________________________________________________________
AirWalk Proprietary and Confidential Page 9 of 54
2.3 Maintenance Information
2.3.1 Cleaning
The AirWalk AW100 units are protected by a high performance paint which does not
require normal maintenance. If paintwork is soiled, it can be cleaned using a damp cloth
after AC power has been disconnected. Do not use liquids or spray cleaning substances
on the unit, since property damage or personal injury may result.
2.3.2 Other Maintenance
Any other required maintenance must be performed by suitable trained service personnel.
Do not open covers or attempt to repair unit if not suitably trained.
2.4 Labeling
2.4.1 Grounding
Proper grounding is recommended to ensure good RF performance in addition to
personnel safety. Antenna systems should also be suitably grounded for good RF
performance.
Grounding connection points on the chassis are located on the rear of the unit and are
identified by this symbol:
2.4.2 Label: Model Identification, FCC Identification, Power
The following illustrates the location of the FCC label that will be applied to the AW100
unit to provide model identification, FCC identification and rated power supply information.
Some units are not equipped with FCC identification and therefore operation of these
units in the US is not permitted.
Figure 2-1 AW100 Main Unit (Bottom - Rear View)
PWR 12VDC RUIF BSIF
BSIF
10MEVENGPS
ANT
TRXRXARXB
Bottom Side o
f
Unit
FCC ID Label
Location