User's Manual

G. Mouse pairing:
The mouse has been already paired before leaving the factory, unless there is
second similar mouse using the same ID code and causing interference with
each other causing not to work, otherwise there is no need to do the pairing
again.
A. Pairing method
1. Use your left finger to press the scrolling wheel (as in picture 1) and while
using your right index finger and middle finger simultaneously, press the left
and right button for about 5 seconds (as in picture 2), until the red LED
indicator at the upper right of the key pad turns on, which means it is ready
for pairing. (as in picture 3)
2. Then use a tiny thin stick (needle-like) to press the pairing button in the
USB adaptor, until the LED in the USB adaptor LED goes out and change
into pairing mode. (as in picture 4)
3. Choose any of the shortcut keys from F1 to F10 within 6 seconds to save
the setting (saving in sequence order from F1 to F10 is recommended).
When the red LED indicator at the upper right of the key pad go out means
that the saving process is confirmed,
4. Plug out the USB adaptor from the USB port and plug it in again, then the
LED indicator in the USB adaptor will light up one more time. If when
clicking the mouse button or when using the sliding plate to move the
mouse cursor it works normally, then it means the pairing process was
successfully done.
5. If the mouse doesn’t work, you need to redo steps 1 to steps 4 above or
check if the device is properly connected.
6. If you need to pair the mouse with more than one computer, then you need
to repeat steps 1~5 above and save respectively in F1~F10 to different
locations.
picture 1 picture 2 picture 3
16