Service manual

14-4
SERVICING
SM CINCO 1-A.1 GB
Remove the nuts fixing the compressor and lift the compressor.
NOTES for re-assembling new compressor:
To1. prevent contamination of the refrigerant with water or foreign particles, do not expose open
pipes to atmosphere for long periods. If necessary, seal pipe ends using caps or tape.
Remove2. the caps for the new compressor just before replacing the compressor. Seal suction
and discharge pipe using tape when mounting to prevent the foreign particles entering the
compressor.
Check to ensure each wire color goes to correct compressor terminal. If wrongly connected, the
compressor may fail due to reverse rotation.
Removing Compressor Insulation Removing Compressor
14.12 Removing Thermistors
Remove the service panels according 1.
to 14.1 and 14.2.
Remove the side and top panels 2.
according to 14.3 and 14.4.
Check to ensure that LEDs and 3.
display board are OFF.
Disconnect the thermistor connector 4.
from the main board.
Remove the thermistor wires from the 5.
cable holders along the electronics
box.
Cut the nylon ties holding the wires to 6.
the pipes.
Pull up the spring from the housing 7.
while pulling the thermistor.
Notes for re-assemble the thermistor:
Make sure the spring is inserted first 1.
and is facing the tube to be attched
to.
hold the thermistor wires to the tube 2.
with nylon tie holding both the wires
and the protective sleeve. Removing Thermistors
Disconnect