Service manual

14-6
SERVICING
SM CINCO 1-A.1 GB
14.15 Removing driver module
Remove the electrical assembly according 1.
to 14.14.
Remove the screws fixing the main board 2.
panel to the assembly and take the panel
out.
Remove the screws fixing the terminal 3.
panel to the assembly and take the panel
out.
Disconnect all the wires from the driver 4.
terminals and the communication
connector.
14.16 Removing Line Filter board
Perform the driver module removal procedure in 1.
14.15.
Open driver assembly cover.2.
Release all wires from the line filter.3.
Squeeze the 4 spacers head with Long-Nose 4.
Pliers and pull out the board.
Removing filter
14.17 Removing Chocks Coils
Remove the chock coil wires from the chock 1.
terminal block.
Remove the 2 screws to release the chock coil 2.
from the partition.
Removing Chocks Coils
Removing driver cover Removing terminal panel