User`s manual

14
3. Note: This step requires two persons. During this
step, you will connect the six assembled leg sections
with the remaining six Top Tubes (1).
Stand two leg sections and hold them in the positions
shown. Slide the large end of one of the remaining Top
Tubes (1) onto the small end of the indicated Top Tube
on one of the leg sections. Insert the small end of the Top
Tube into the indicated Top Tube with Socket on the
other leg section. Repeat this step until all six leg sec-
tions are connected. When this step is completed, the
frame will be fully assembled and freestanding as shown.
4. Lay the jump mat (5) on the ground inside the assembled
frame. Make sure that the two warning decals are on
top of the Mat and are located in the center, between the
two legs of the trampoline as shown.
Note: There are
Be sure to place the enclosure door opening located directly over
the T-Joint, with the warning label centered between the two legs of
the trampoline as shown.
96 V-rings around the edge of the Mat (5)
and 96 holes around the top of the frame. In Steps 4 and 5
you will attach the Mat (5) to the frame, using 96 Springs (11)
Caution: It is wise to wear leather gloves while attach-
ing the Springs. Be careful w
he
re you place
y
our
hands as the Springs and frame joints can pinch.
For proper placement of jump mat, locate the first V-ring located
directly left of the enclosure opening, and apply the first spring as follows:
Attach the spring with the smaller hook end onto the V-ring located directly
left of the enclosure opening, once you have done so hook the spring tool onto
the opposite end and pull the spring towards the frame (as pictured in the inset drawing),
then push the spring into the spring hole located on the main frame top tube.
Once this has been done, remove the spring tool and move 24 spring holes and V-rings
in the clockwise direction and apply another spring. After you have now attached the
second spring, count an additional 24 spring holes and V-rings in the clockwise direction
and apply the third spring and continue the same pattern until you have exactly 4
springs attached to the main frame.
Flip two of the leg sections over so that the spring holes are
now facing the sky instead of the ground.
1
2
Leg Section
Leg Section
Small
End
Large
End
5
11
11
11
11
Warning Label locate in the
center between the two legs
of the trampoline as shown
If the enclosure was pre-installed on the Bed (Mat)
at the factory. Inspect the attachments of the enclosure
Netting to the trampoline mat (bed). Make certain each of
the V-rings on the trampoline mat (bed) is threaded
through the corresponding “buttonhole” in the Netting.
Put enclosure mesh
(7) on the jump mat.
Insert one of the V-rings on the jump mat into one of the
"buttonhole" incisions on the bottom edge of the enclosure
mesh. Continue this process to the other V-rings one by one,
until all the V-rings are inserted though the “buttonholes”
of the enclosure mesh. Make certain that each of the V-
rings on the trampoline mat is threaded through the
corresponding 'buttonhole' in the enclosure netting,
and that the door opening of the enclosure is located near
the warning label of Jump mat.
Make sure the enclosure
door and T-joint are aligned