User's Manual

KDC User Manual

Revision 3.05.R6

2. Installation

Bluetooth Pairing 2.1

KDC itself reads barcodes independently, and it can also be used in combination with PC,

PDA, or smart phones. When you want to read barcodes with KDC in connection with

other devices, you need to conduct pairing between your KDC and smart phone via

Bluetooth first. Unless there are changes in Bluetooth settings, your smart phone will

always recognize your KDC that has already been paired. However, if you change

Bluetooth settings, you need to go through pairing process for your KDC again. You can

also refer to Chapter 4. BLUETOOTH for more information about Bluetooth pairing.

2.1.1 Preparing for Pairing

1. Turn on the power first if you are a KDC20 user.

2. Set a Bluetooth device type mode. There are two ways to set a Bluetooth device

type mode.

 Select and scan your Bluetooth device type barcode among the barcodes below, or



Bluetooth Device type Bluetooth Device type iOS Bluetooth Device type

HID SPP IPHONE

Press SCAN and DOWN

buttons simultaneously for 5

seconds. You will hear beep

sound when it is turned on.

Figure 3 – How to turn on the power in KDC20