User's Manual

KDC User Manual
35
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
Battery
% of Battery Charge Available
Version
Firmware Version & Serial No.
Button Lock
Enabled/Disabled
Disabled
Beep Sound
Enabled/Disabled
Enabled
Power On Beep
Enabled/Disabled
Enabled
Beep On Connect
Enabled/Disabled
Enabled
Beep On Scan
Enabled/Disabled
Enabled
Beep Volume
Low/High
Low
MFi Mode
Enabled/Disabled
Enabled
Vibrator
Enabled/Disabled
Enabled
Auto Exit
Enabled/Disabled
Enabled
Port Status
Enabled/Disabled
Enabled
Display Format
Time & Battery / Type & Time / Type &
Battery / Memory Status / GPS
Data(KDC250/350)/Barcode Only
Time & Battery
Menu Barcode
Enabled/ Disabled
Disabled
Scrolling
Enabled/Disabled
Enabled
Brightness
1 to 15 level(8 level)
8 level
Factory Default
Restores Default Settings
Table 2 – KDC20 Menu Options
3.3.1 Set Barcodes Menu
This menu lists all the barcode symbologies supported by your KDC and allows you to
select the barcode symbologies you will be scanning. For maximum scan performance,
you should select only the symbologies you are scanning. Please refer to 11. Appendix –
11.1 Symbologies for a detailed listing of symbologies supported by your KDC.
3.3.2 Code Options Menu
Your KDC supports various Code Options including Transmission of Start and Stop
Characters, Symbology Conversion, Verification of Optional Check Character, and
Transmission of Check Digit. Please refer to 11. Appendix A – 11.2 Code Options for a
detailed explanation of each option.
3.3.3 Scan Options Menu
 Scan Angle (Opticon model only): Allows you to configure the laser beam angle
to the barcode. There are two options for scan angle: Wide and Narrow. Wide is