User's Manual

KDC User Manual

Revision 3.05.R6

4.1.2 Auto Connect

This feature allows the KDC to connect automatically to the host device when the KDC is

powered on.

IMPORTANT: Until the host device and KDC have been fully tested, it is strongly

recommended that this feature be set to Disable because a host device that does not

support this feature can cause problems such as power loss or upload delays.

[Note] KDC automatically tries to connect to the host 10 times during two minutes when

Bluetooth

power is ON,

Bluetooth

is disconnected, Auto Connect is enabled and system

Sleep Timeout is set to 5 seconds

4.1.3 Auto Reconnect

This feature allows the KDC to connect automatically to the host device when the KDC is

disconnected from a host.

IMPORTANT: This feature is available when KDC “Connect Device” options are

“iPhone”,”HID iOS” and “HID Normal “.

Note:



KDC tries to connect automatically to the host 10 times during two minutes if

Bluetooth

is disconnected.

4.1.4 Auto Power On

The Auto Power On option allows the KDC to automatically power on Bluetooth when

the SCAN button is depressed. The default setting is Disabled.

NOTE: The host may have to open the COM port before reconnecting with the KDC.

Power-on time determines the scan button pressing time to activate Auto Power On

feature.

4.1.5 PWR ON Time

The PWR On Time option works in conjunction with the Auto Power On option. Default

value is Disabled. If KDC Bluetooth power is off, user can turn on Bluetooth power by

pressing SCAN button for PWR On Time option value.