User's Manual

KDC User Manual

Revision 3.05.R6

Bluetooth Service 4.2

4.2.1 Power

The POWER option allows you to Enable or Disable the Bluetooth functionality of the KDC.

To use Bluetooth, this option must be set to Enable. However, like all devices enabled for

Bluetooth, the KDC will search constantly to connect with a Bluetooth host when set to

Enable. Constant searching for Bluetooth devices increases power consumption. Unless

you are using Bluetooth with your KDC, this option should be set to Disable.

IMPORTANT: To prevent unnecessary power problems, it is strongly recommended that

the POWER option be set to Disable if the KDC is idle for an extended period of time.

4.2.2 Pairing

Before you are able to use Bluetooth, the KDC must be paired with the host device. This

pairing process only needs to be completed once with each host device. After pairing, the

host device will always recognize the KDC as a Bluetooth device unless the Bluetooth

configuration is modified. If it is modified, you may need to pair the devices again.

IMPORTANT: The host device must be configured for Bluetooth before it can be paired

to the KDC.

Note:



KDC with Bluetooth Spec2.1+EDR doesn’t prompt Pin code entry menu.

To pair the KDC with the host, follow these instructions.

1. Select Pairing from the Bluetooth menu. The message “Pairing started…”

will displayed.

2. When prompted by the host device, enter the Security PIN “0000”.

3. The “Pairing success” message will display when the Bluetooth connection

is successfully established. The connection must be established before the

pairing timeout which is 60 seconds.

 If “Pairing failed...” message displays, the Bluetooth connection with the host

device failed. If the message “Connected” displays, a Bluetooth connection

is established.