User's Manual

KDC User Manual
54
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
 It is possible for the message “Pairing failed...” to display on the KDC while
the host device displays “Connected” message. If this occurs, a Bluetooth
connection is established.
4.2.3 Discovering
KDC20 starts to search neighboring Bluetooth devices if this Discovering menu is
executed. It would take about 30 seconds to finish search and list available neighboring
Bluetooth devices. User may enter corresponding Bluetooth MAC address in KTSync
Bluetooth menu instead of searching neighborhood Bluetooth devices.
4.2.4 Connect To
This option lets you easily connect KDC to Bluetooth devices either previously registered
in KTSync under the File Menu or discovered/connected from KDC Bluetooth Service
menu.
Note:
 There could be an interoperability issue depending on corresponding device
Bluetooth stack. Master Bluetooth device may request to follow master
Bluetooth device security procedure if KDC tries to connect to the master
Bluetooth device.
4.2.5 HID Sync
User can synchronize stored barcode data over HID using HID Sync option. KDC starts to
transmit all stored barcode data upon executing HID Sync option. This option is available
when KDC MFi Mode option is disabled.