User's Manual

KDC User Manual

Revision 3.05.R6

Clear KDC Memory after Synchronization

The stored barcode data is cleared from the KDC memory after synchronization if this

option is selected. The KDC20 can store a total of 10,240 barcodes or 60KB (86

version)/160KB (85 version) of barcode data.

 It is important to clear the KDC memory periodically to prevent Buffer Full

message which will prevent the KDC from storing additional data. Stored barcode

data can also be deleted using the Reset Memory feature on the KDC.

Automatically Synchronize after Connection

This option lets you automatically synchronize collected data to your computer

immediately when the KDC is connected to the host.

 IMPORTANT: Remember to configure all options properly before selecting this

option.

 Data synchronization can be done manually by clicking the synchronize icon if this

option is not selected.

Beep while Synchronization

You can enable or disable the beep tone during the synchronization process. A beep is

sounded each and every time barcode data is synchronized if this option is selected.

The KDC beeps 5 times when the synchronization process is complete.

Append data to File

KTSync would append data to the exiting file instead of creating a new file if user has

specified file name and Append data to File option is enabled.

5.3.3 Current KDC Wedge Method

The KDC can be configured in one of five Wedge/Store modes

 Wedge Only - Scanned data is transmitted to the host. The KDC does not store

scanned data.

 Wedge & Store - Scanned data is stored in the KDC and transmitted to the host.

 Store Only - Scanned data is stored in the KDC but NOT transmitted to the host.

 Save if Sent - Scanned data is stored in the KDC ONLY if transmission to the host

is successful.

 Save if Not Sent - Scanned data is stored in the KDC ONLY if transmission to the

host is unsuccessful.