User's Manual

KDC User YOUR KDC
108
3.7 Reset Feature (100/200/250/300) or
Power-on/off (KDC20/30/270/350/400/470/500)
The Reset feature enables the user to restart the KDC100/200/250/300 if necessary,
without losing any stored barcode data or option settings. To reset the KDC, follow the
below steps.
1. Press the DOWN and SCAN buttons simultaneously for 5 seconds.
2. When the LEDs illuminate orange, release the buttons.
3. The KDC initial screen, KoamTac Data Collector KDC, displays when reset is
complete.
The KDC stores collected data into flash memory and will not lose data nor
the KDC settings during the reset process.
If you are using the KDC20/30/270/350/470, you may turn the power on and off by
pressing the DOWN and SCAN button simultaneously for 5 seconds. When the LED
light is green, you may release the buttons and the power will be on. When you turn off
the KDC20/30/270/350/470, you will hear a beep sound after pressing the DOWN and
SCAN buttons simultaneously.
If you are using the KDC400 (except KDC470) you may turn the power on and off by
sliding the power switch.
If you are using the KDC500, you can turn the power on and off by pressing the left and
right SCAN buttons simultaneously for 5 seconds. When the display shows KOAMTAC
logo, you may release the buttons and the power will be on. When you turn off the
KDC500, you will see the display shows blank after pressing the left and right SCAN
buttons simultaneously.
Note