User's Manual

KDC User YOUR KDC
109
1
Unscrew the screw indicated by
the arrow.
2
Remove the battery cover by
pulling it down.
3
Remove the battery.
Pull out the 2 pin connecter
gently.
3.8 Replace Battery
Each KDC comes with a rechargeable, Lithium-polymer (KDC20/100/200) or Lithium-
ion (KDC30/250/300/270/350/400/470/500) battery. The battery may be recharged
from any USB port or KDC charging cradle, and may be recharged about 300 times
before it needs to be replaced. KOAMTAC recommends replacing the battery annually,
as a declining battery will cause noticeable performance degradation in the KDC.
Replacement batteries may be purchased from a KDC reseller. Batteries should be
disposed of properly as according to the WEEE regulation. The steps for replacing a
battery are as follows.
1. Disassemble the KDC back cover by unscrewing the middle screw.
2. Remove the old battery and replace with a new battery.
3. Reassemble the back cover.
Figure 15 - Replacing a Battery