User's Manual

KDC User Manual BLUETOOTH
117
Bluetooth connection has been established.
For KDC500 paring with the host, Numeric Comparions pairing method is required for
PCI PTS complicance. See the section 2.1 Bluetooth Paring for the details.
Discovering
KDC200/250/270/300/350 starts to search for neighboring Bluetooth devices if the
Discovering menu is executed. It will take about 30 seconds to finish searching and to
list available neighboring Bluetooth devices. Another option is to enter the
corresponding Bluetooth MAC address in the KTSync Bluetooth menu, instead of
waiting for the KDC to search for neighborhood Bluetooth devices. KDC20/30/400/470
only supports via KTSync configuration. KDC500 doesn’t support this feature.
Connect To
This option lets you easily connect the KDC to Bluetooth devices that have been either
previously registered in KTSync under the File Menu or discovered/connected from the
KDC Bluetooth Service menu. KDC20/30/400/470 only supports via KTSync
configuration. KDC500 doesn’t support this feature.
There could be an interoperability issue depending on the corresponding
device Bluetooth stack. The master Bluetooth device may request that you
to follow the master Bluetooth device’s security procedures, if the KDC tries
to connect to the master Bluetooth device.
HID Sync
The user may synchronize stored barcode data over HID using the HID Sync option.
The KDC will start to transmit all stored barcode data upon execution of the HID Sync
option. KDC500 doesn’t support this feature.
Tips
Pair and connect KDC20i/30i/200i/250i/270i/300i/350i/400i/470i and iOS4.0+ in HID iOS
mode
 Users have to disable the MFi option in System > MFi menu and change
the Bluetooth profile to HID-iOS to use HID Bluetooth profiles .
Note
Note