User's Manual

KDC User Manual Installation

2. Installation

2.1 Bluetooth Pairing

The KDC may read and store barcode data independently, but it may also be used in

conjunction with a PC, PDA, or smart device.

In order to read barcode data with your KDC wirelessly, the user must first pair the KDC

and smart device via Bluetooth. If previously paired and no changes have been made

in the smart device’s Bluetooth settings, the smart device will always recognize the KDC

that has previously been paired. However, if changes have been made, the user may

need to go through the pairing process again. The user may also refer to Chapter 4.

Bluetooth for more information about Bluetooth pairing.

Preparing for Pairing

Select a Bluetooth profile. There are two ways to set up a Bluetooth profile. The user

may establish a Bluetooth profile manually (on the scanner) or by scanning a

programming barcode as shown below.

KDC 20/100/200/250/270L/270D/350L/410/411/415/470L/470D/500L (1D)

Bluetooth Profile SPP Bluetooth Profile HID iOS Bluetooth Profile MFi

Bluetooth Profile SPP2.0 Bluetooth Profile HID normal

For PCI PTS compliance, KDC500L supports only Bluetooth Profile SPP

and MFi.

Note