User's Manual

KDC User YOUR KDC

Charge KDC Battery

Prior to using the KDC, the user should charge the battery. Follow the instructions

below.

1. Connect the KDC cable to the mini USB connector on the KDC.

2. Connect the KDC cable to the Type A USB connector on the computer.

3. The KDC battery will begin charging. Within a few minutes, the two small LEDs

(three LEDs in case of KDC500) on the front panel will illuminate orange. When

the battery is fully charged, the LEDs will illuminate green.

Configure KDC

The KDC is designed to meet the data collection requirements of many different

industries in a variety of dynamic situations. To deliver the best performance in these

diverse environments, the KDC is designed to be configured quickly and easily.

However, to perform at its optimum level, the KDC must be configured properly. Until

the user is familiar with the KDC configuration settings, it is recommended that the

user DOES NOT modify the KDC settings. The KDC may be configured by using three

different methods, which are explained in Section 3.3 – KDC Menus, Chapter 5 –

Synchronization, and Appendix C/D – Special Barcodes.

CONFIGURATION METHODS FOR THE KDC100/200/250/300/270/350/500

 KDC Menu

 KTSync Software

 Special Barcodes

KDC100

KDC20/200

KDC30/250/300/270

KDC350

KDC400/470

KDC500

2 Hours

4 Hours

5 Hours

Table 2 - Number of hours required to fully charge a KDC Battery