User's Manual

KDC User YOUR KDC

Read Magnetic-Stripe (MS) Card(KDC500)

1. The paired host application sends a command to enable the MS Card Reader.

2. Swipe MS Card either top to bottom or bottom to top. Make sure the magnetic stripe

of the card face to the KDC500.

3. The KDC500 will send the MS card data to the paired host application and the user

will hear a short beep if it has been read successfully.

Read Integrated Chip (IC) Card(KDC500)

1. The paired host application sends a command to enable the IC Card Reader.

2. Insert IC Card into the IC Card slot located in the left side of KDC500. Make sure the

IC of the card face to up.

3. The KDC500 will send the IC card data read to the paired host application.

Synchronizing data to the host device

Use the KTSync

program to synchronize barcode data from the KDC to the host device.

Please refer to Chapter 5. Synchronization for details.