User's Manual

KDC User YOUR KDC

OCR Passport

OCR MICR

OCR SEMI

Image Capture

(KDC30/270C/300/350C/420/421/425/450/470C)

This option enables the user to capture an image in JPEG format in C:\myData folder.

You should enable the image capture option first, and then press the Scan button to

start the aiming. A green aiming light will illuminate and an image will be taken upon

release of the Scan button. KDC will disable the image capture option if the user

presses the scan button for 5 seconds.

Security Level

(Laser Model only)

This menu enables the user to ensure an accurate barcode reading by setting the

number of times the KDC will read a barcode. Security Level is set from 1 up to 4. The

higher security level means readings are more reliable; however, some performance

degradation is likely. For poor quality barcodes, we recommend increasing the security

level. The default is 2.

Auto Trigger

Once enabled, Auto Trigger enables the user to scan a barcode automatically. You

may adjust reread delay from continuous to extra-long. Auto Trigger mode always

enables the duplicate check option.(1D Model only)



USB cable insertion requirement is removed from FW2.85/86.O and FW

3.02.



You may exit the auto trigger mode by pressing the scan button for 3

seconds.

Reread Delay

You may adjust the reread delay from continuous to extra-long.

Partial Display

This option enables the user to display partial data. You may define the start position

and number of characters to be displayed.

Table 4 - KDC30/270C/300/350C/420/450/470C/500C Minimum Barcode Length

Note