User's Manual

KDC User Manual
41
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
To configure your KDC for Bluetooth functionality, you must use the KDC Menus. To
access the menus, simultaneously press the UP and DOWN buttons on the side of the
KDC. Use the DOWN button to scroll to Bluetooth then press SCAN button.
Below is a listing of the Bluetooth options and their settings. The default settings for
these options have been set to increase the usability of Bluetooth technology without
compromising the KDC battery usage.
IMPORTANT: We strongly recommend NOT changing these settings until you have fully
tested the Bluetooth connection between the KDC and the host device.
For more detailed information regarding Bluetooth functionality with the KDC, please
refer to Chapter 4. BLUETOOTH.
 ConnectDevice: Users can choose Bluetooth device type
Options - HID normal (KDC30)
- HID iOS (KDC30)
- SPP2.0
- SPP(KDC30/30i)
- iPhone (KDC30i)
 Auto Connect : Enabled or Disabled
 Auto Reconnect: Enabled or Disabled (iPhone, HID iOS, HID normal mode)
 Auto Power On: Enabled or Disabled
 PWR On Time: Disabled, 1 to 10 seconds
 Auto Power Off : Enabled or Disabled
 Beep Warning - Enabled or Disabled
 PWR Off Time - 1 to 30 Minutes
 PowerOff Msg – Enabled or Disabled
 MAC Address – 12 characters Bluetooth MAC Address
 FW Version – Display Bluetooth Firmware Version
 Wakeup Nulls – Enabled or Disabled
 Autolock Time – 0, 1, 2, 3, 4, 5, 10, 15 minutes
 BT Toggle – Enable or Disable HID soft keyboard or iPhone mode
connection On/Off toggle.
 BT Disconnect Button – Enable or Disable Bluetooth disconnection by
pressing down button for 3 seconds.
 HID AutoLock - Disabled, 1, 2, 3, 4, 5, 10, 15 minutes
 HID Keyboard – English, German, French, Spanish, Italian
 HID Initial Delay- Define the initial delay between 1 second to 10 seconds
before data transmission in HID mode
 HID Inter-character Delay - Define the inter-character delay between 10msec