User's Manual

KDC User Manual
42
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
to 100msec in HID mode
 HID Control Character - Map control characters to either ALT+Numlock or
^+Character.
3.3.6 BT Service
 Power : Turning on or off Bluetooth Power
Options – Enable/Disable
 Pairing Mode
- KDC enters pairing mode so that host Bluetooth device can search KDC.
- KDC exits pairing mode either by pressing SCAN button or it fails to pair
with Bluetooth host device in 90 seconds.
 Discovering: Search neighborhood Bluetooth devices
 Connecting To: Inquiry to registered Bluetooth devices
 HID Sync: KDC transmits all stored data to the host over HID profile if HID
Sync option is enabled
3.3.7 System Menu
 Memory Size (3.0 version only)
 User can select normal data and application database memory partition size.
 KDC will erase all stored data upon changing the partition size.
 User should enter the following key sequence to change the partition.
 UP button + UP button + DOWN button + DOWN button + SCAN button
 Memory Status: Checks the number of stored barcodes and memory usage.
 Reset Memory: Resets KDC memory by erasing all stored barcodes, application
and BT registry.
 Auto Erase: Erases all stored barcodes upon reaching buffer full condition if
Enabled is selected
 Sleep Timeout: Sets amount of time KDC waits, when not being used, before
going to sleep.
 Date/Time: Sets the date and time of KDC which can also be set using KTSync
®
 Battery: Shows current status of battery power level.
 Version: Shows KDC firmware version and serial number.
 Button Lock: Locks or unlocks KDC scan and scroll buttons.
 Beep Alert
 Beep Sound: Enables or disables KDC beep sound.
 Power On Beep: Enables or disables beep sound when KDC power is on.
 Beep On Connect: Enables or disables beep sound when KDC is connected to
host.