User's Manual

KDC300 User Manual
7
Charge the battery
The battery is charged by connecting KDC300 to a USB port. It takes about four hours to fully charge the
battery. The front panel LED will illuminate in orange during the battery charge. The front panel LED will
illuminate in green when the battery is fully charged.
Configure KDC300 options and system settings
User can access menu selection mode by pushing both buttons on the left side of the KDC300
simultaneously.
z Please set KDC300 options properly for the best performance.
z Please refer KDC300 menus section for the details on options.
Note
User also can configure KDC300 from KTSync program as well as
reading special barcodes. Please refer to Chapter 4 Synchronization
and Appendix C for the detailed description of each option