User's Manual

K
KDC User YOUR KDC


Figure 13 - Location for reading NFC Tag
3. The KDC will show the NFC tag UID and the user will hear a short beep if it has been read
successfully.
Reading HF RFID Tags (KDC450/470)
The KDC450/470 may virtually read any ISO/IEC 14443 A or B compliant smartcards, or ISO/IEC
15693 compliant HF RFID tags.
To read a HF RFID tag, touch the RFID card to the back of the KDC450/470 case, and make sure the
tag and case are within 5cm of each other. The user will hear a short beep if it has been read
successfully.
Inputting Data by Using a Keypad (KDC350)
The KDC350 Enables users to input barcode data by using its keypad. The user may switch between
Num mode and Abc mode by using the Mode button.
To switch between uppercase and lowercase letters, the user may press the Shift button while in
Abc mode. To save the data input, press the Enter or SCAN button. For data input, press the Menu
button. Refer to 1.5 Input data by using a keypad (KDC350) for more detailed information about the
process.
Read Magnetic-Stripe (MS) Card(KDC500)
1. The paired host application sends a command to enable the MS Card Reader.
2. Swipe MS Card either top to bottom or bottom to top. Make sure the magnetic stripe of the card
face to the KDC500.
3. The KDC500 will send the MS card data to the paired host application and the user will hear a
short beep if it has been read successfully.