User's Manual

KDC User Manual APPLICATION

GENERATION

Revision 1.0

3. Operating your KDC500

3.1 Getting Started

Charge KDC500 Battery

Prior to using the KDC500, the user should charge its battery by following the below

instructions.

1. Connect the KDC500 cable to the micro USB connector on the KDC500.

2. Connect the KDC500 cable to the Type A USB connector on the computer.

3. The KDC500 battery will begin charging. Within a few minutes, the LED on the

front panel will illuminate orange. When the battery is fully charged, the LEDs

will illuminate green. It will require 5 hours to fully charge a KDC500 Battery.

3.2 Basics

Read barcodes

To read a barcode using the KDC500, simply point the KDC500 at a barcode and press

the scan button. Be sure to point the scan engine window at the barcode, not at the

user’s face, and make sure to position the light beam on the barcode.

If a barcode has been successfully scanned, the user will hear one short beep and the

LED will illuminate green. The scanned barcode data will be displayed on the KDC500

screen.

If scanning was unsuccessful, the user will hear two short beeps, the LEDs will

illuminate red, and the message

Reading failed…

will display. If this is the case, the