User`s guide
Using the Profiles
53
The TV Setup
You can establish TV channel lists, set spending limits, and set rating
limits for TV programs using the TV Setup menu.
Editing Channels in a TV List
You should create a TV channel list to establish which TV channels
(including both analog and digital) the selected profile can access.
To create the TV channel list:
1. Select a user.
2. Select Edit Channels.
To start, you can add or delete all channels.
3. Use the arrow buttons to highlight a TV channel, and press OK
to remove (or replace) the check mark. To go directly to a
certain channel, enter its number using the digits on the remote
control. Or, page through the list using the channel up and
down buttons.
Checkmarked items appear in the channel list. In other words, when
you select that profile and begin surfing through TV channels, only
the checkmarked channels will appear as you surf. Note that the
only channels you can add to a list are ones that were found during
the channel search (see the “Getting Assistance” section in this book
for details on automatically searching for channels).
Selecting or Deleting all TV channels
You might be able to save time when creating a TV channel list by
using the Select All Chans option or the Delete All Chans option to
either add or delete all channels before removing or adding
individual channels.
Also, terrestrial program providers may make additional channels or
subchannels available. To include new channels in your TV channel
list:
1. Select System Options from the main menu, then select Channel
Search. The system will run a channel search, making it aware of
the new channel(s).
2. Select Profiles from the main menu.
3. Select the user profile name, then TV Setup.
4. Choose Edit Channels and checkmark the new channel.
Don’t forget about the CLEAR button.
Press the CLEAR button on the remote control
to remove the on-screen menus and return to
normal viewing.
Note that if you’re using two terrestrial
antennas, pressing the ANTENNA button on
the remote allows you to edit the other
antenna’s channel list when you are in
TV mode.
Another way to add a channel to the channel
list is to directly tune to it using the digit
buttons on the remote control. If the system
can obtain that channel’s signal, that channel
will be added into the channel list.