OPERATING INSTRUCTIONS MANUAL DE INSTRUCCIONES MODE D’EMPLOI CDC-X427 YUC STEREO CAR CD RECEIVER RADIO-TOCADISCOS DE CD ESTEREOFONICO PARA AUTOMOVIL ENGLISH ESPAÑOL FRANÇAIS OWNER’S RECORD For your convenience, record the model number and serial number (you will find them on the bottom side of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty. Model No. CDC-X427 Serial No.
PRECAUTIONS TABLE OF CONTENTS • Use only in a 12-volt DC negative-ground electrical system. • Disconnect the vehicle’s negative battery terminal while mounting and connecting the unit. • When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. • Do NOT attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to the eyes.
THEFT PROTECTION Take the front panel with you when leaving the car, and keep it in the supplied carrying case. BASIC OPERATION, AUDIO AND CLOCK ADJUSTMENT Detaching the front panel Before detaching the front panel, remove the CD to prevent possible damage to the unit. PWR/MUTE SEL AUDIO CONTROL 1 Press z to remove the CD. 2 Press and hold PWR/MUTE until the unit turns off. 3 Press %. (Hold the panel with one hand to prevent accidentally dropping it.) 4 Remove the panel.
Adjusting sound You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/ rear) and H-BASS (high bass). 1 Press SEL repeatedly to select the mode to be adjusted. Pressing SEL cycles through the modes. The selected mode’s indicator flashes. 2 Turn AUDIO CONTROL to increase/decrease the level or to select on/off for the selected mode.
Presetting stations manually Monaural mode When signals become weak, or reception becomes poor, the unit automatically switches to Monaural mode to reduce noise. (Manual Memory) 1 Press BAND repeatedly to select the desired band (FM1, FM2, FM3, AM1, or AM2). Local mode 2 Press i or k to tune in to a desired station (see Local mode allows you to tune in only to strong stations during Seek Tuning. 1 Press LO before you start seek tuning. “LO” appears in the display.
Labeled-side up Intro Play You can locate a desired track by monitoring the first 10 seconds of all the tracks on a CD. 1 Press INT during CD play. “SCAN” appears in the display. 2 Press INT again when the desired track is played. The unit returns to normal CD play. Track number One track Repeat Play You can play a track repeatedly. 1 Press REP1 during CD play. “REPEAT1” appears in the display. To cancel One track Repeat Play, press REP1 again.
OTHER FUNCTIONS Preparations A lithium battery is installed in the remote control at the factory. Before you use the remote control, be sure to remove the insulating sheet by simply pulling it out. Remote control (back) AUDIO CONTROL SRC Changing the key illumination color You can choose blue or red as the key illumination color. 1 Press and hold SRC until “ILL” appears in the display. 2 Turn AUDIO CONTROL to select 1 (for blue) or 2 (for red).
TROUBLESHOOTING SPECIFICATIONS Error code RADIO SECTION In the following cases the corresponding error code indication appears. Follow the suggestions below to solve such problems. If the error code indication does not disappear, consult an AIWA service center. (FM) E03 Focus error. Check that the CD is loaded properly (right side up, etc.), and the CD contains valid data. Reset button If a CD does not operate properly, press the reset button with a pointed object such as a pencil, etc.
Printed in Indonesia