OPERATING INSTRUCTIONS INSTRUCCIONES DE MANEJO MODE D’EMPLOI CSD-TD39 CSD-TD49 CD STEREO RADIO CASSETTE RECORDER RADIOCASETE ESTÉREO CON REPRODUCTOR DE DISCOS COMPACTOS RADIO-CASSETTE LECTEUR DE CD STEREO English : See page 2. 8C-CHB-903-01 020205ACK-I-AL En Español : Ver la página 12. E Français : Voir page 22.
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN “CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.” IMPORTANT SAFETY Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference.
INSTRUCTIONS Object and Liquid Entry – Never push objects of any kind into this unit through the cabinet slots as they may touch dangerous voltage points or short-circuit parts that could result in a fire or electric shock. Never spill liquid of any kind on the unit. Electric Power Power Sources – This unit should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company.
Power supply Using on batteries OPE/BATT Open the lid of the battery compartment on the rear and insert eight R14 (size C) batteries, not supplied, as illustrated below. Then close the lid. To switch from AC power supply to battery supply, disconnect the AC cord from the AC inlet. The OPE/BATT indicator lights up while the power is on. R14 (C) Using on AC house current Connect the AC cord as illustrated below.
Remote control (CSD-TD49 only) Specifications Insert two R6 (size AA) batteries. Tuner section Frequency range, antenna – FM: 87.5 - 108.0 MHz Rod antenna, AM: 530/531 - 1,710/1,602 kHz (10/9 kHz step) Ferrite bar antenna Deck section R6 (AA) When the reach of the remote control signal is less than 5 meters (16 feet), replace the batteries.
\ PHONES VOLUMEN,M e PLAY/PAUSE POWER 6STANDBY/ON f, g (TUNING -, +) 3-MODE EQ s STOP/SET/CLEAR T-BASS PRESET RADIO BAND A 1 REPEAT/MODE/ SLEEP TUNER OPERATION Press RADIO BAND * repeatedly to select the desired band. FM AM The power is turned on and the previously tuned station is received. * or BAND on the remote control (applicable when the AC cord is connected, CSD-TD49 only) 2 Press f, g (TUNING -, +) to select a station. During FM stereo reception, is displayed.
DISPLAY 0-9, +10 SOUND ADJUSTMENT MODE Volume or tone adjustment does not affect recording. EQ VOL k, i BAND e PLAY/ PAUSE f, g s STOP (CSD-TD49 only) VOLUME (VOL, CSD-TD49 only) Press VOLUME N or M on the unit or VOL i or k on the remote control. The volume level is displayed as a number from 0 to 25. • The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more.
e PLAY/PAUSE POWER 6STANDBY/ON f, g s STOP/SET/CLEAR CD REPEAT/MODE/ SLEEP B 1 CD OPERATION Press CD. The power is turned on. 2 Press PUSH OPEN to open the disc compartment. Place a disc with the printed side up and close the disc compartment. PUSH OPEN Total number of tracks and total playing time are displayed. It will take about 15 seconds when loading a CD-RW disc. 3 Press e PLAY/PAUSE to start play. The number of the track being played and elapsed playing time are displayed.
0-9, +10 REPEAT e PLAY/PAUSE f, g s STOP (CSD-TD49 only) PROGRAMMED PLAY Up to 30 tracks can be programmed from the disc. 1 In stop mode, hold down s STOP/SET/ CLEAR * until “M” flashes in the display. The program number, “P-01” is also displayed. * or s STOP on the remote control (CSD-TD49 only) 2 Press f or g to select a track, then press s to store it. Next program number Pressing the numbered buttons 0-9 and +10 on the remote control selects and stores the track at the same time (CSD-TD49 only).
e PLAY/PAUSE POWER 6STANDBY/ON REC f, g TAPE s STOP/SET/CLEAR REPEAT/MODE/ SLEEP C TAPE OPERATION • Use Type I (normal) tapes only. • The unit plays (records on) the side facing up. PLAYBACK 1 Press TAPE. The power is turned on. 2 Press PUSH EJECT to open the cassette holder and insert a tape with the side to be played facing out and the exposed side facing down. To set the tape counter to “0000” Press s in stop mode. The counter is also set to “0000” when opening the cassette holder.
SETTING THE SLEEP TIMER e PLAY/ PAUSE MODE The unit can be turned off automatically at a specified time. 1 w REC * or MODE on the remote control (CSD-TD49 only) f, g s STOP (CSD-TD49 only) Hold down REPEAT/MODE/SLEEP * until “SLEEP” flashes in the display. 2 Within 4 seconds, press f or g to specify the time until the power is turned off. Each time it is pressed, the time changes between 10 and 180 minutes in 10-minute steps.
NOTE REMARQUE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
