Operation Manual

MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily,
Press the - or - button during playback referring to the
playback side indicator (< or F) on the display.
For example, when the FP button is pressed while E is
displayed, playback of the next track starts,
Music sensor function may not be able to detect tracks under
the following conditions:
● Blanks of less than 4 seconds between tracks
● Noisy blanks
● Long passages of low-end sound
● Low overall recording levels
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press the TAPE/DECKl/2 button to select the
deck to be played back first.
Press the REV MODE button to select Z).
Press the <F button to start playback.
Playback continues until the ❑ button is pressed.
——
About cassette tapes
● To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
a
Side A
‘T-s’abol]
—.-—
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type
IItapes, take care not to
cover the Type 11tape detection slot. )
● 120-minute or longer tapes are extremely thin and easily
deformed or damaged, They are not recommended.
● Take up any slack in the tape with a pencil or similar tool
before use. Slack tape
mi~y break or jam in the mechanism.
P
)-:
&
<
DOLBY NR
system
The Dolby Noise Reduction system reduces tape hiss noise,
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOL.BY
N R system,
—.
E/UGL/SH
12