Operation Manual

m
PLAY WITH DOLBY PRO LOGIC
,,., ––––– –,––––, ––, – –,–. ,!– –-,,= na, ,., n.–– ,. —–. ––,
————.
IT me surrouna speaKers level OTme aumnuu Ivu IS cnangea
(see page 7), that of the DOLBY PRO LOGIC is also changed.
About the channels
The left and right speakers
create the stereo effect,
The center speaker helps achieve precise sound positioning
over a broad sound field.
The rear-mounted surround speakers enhance the “depth” of
the sound field,
To
change the delay time
The surround speakers reproduce sounds a split second after
the front speakers. The delay is initially set to 21 ms
(milliseconds),
To change this standard delay time, press the MANUAL SELECT
(TEST) button on the remote control repeatedly until “TIME” is
displayed, Then, press the DOWN 1< or UP
➤M button. Each
time one of the buttons is pressed, the delay time changes as
shown below.
15mS+21mS~30mS
1
!
2
DOLBY PRO LCIGIC
DOLBY
PRO LOGIC
Press the VIDEO/AIJX button and start playback
of the video source.
Press the DOLBY PRO LOGIC button.
NORMAL is selected, and the playback sound has the DOLBY
PRO LOGIC effect,
To cancel Dolby Pro Logic mode
Press the DOLBY PRO LOGIC button repeatedly until P-OFF is
displayed,
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sourld
levels of the center or surround speakers can be adljusted during
playback of laser discs or video software.
1 Press the MANUAL SELECT (TEST) button on the remo!e
control repeatedly to select “CEN” (center) or “SUF{”
(surround).
2 While the “CEN” or “SUR” is displayed, press the DOWIN 1<.4
or UP
➤>1 button on the remote contrc)l to adjust the velume.
ADDITIONAL DOLlBY PRO LOGIIC MO[)ES
In addition to the NORMAL mode, this unit is also equipped with
the PHANTOM and the 3 CH LOGIC modes.
PHANTOM mode: Use thie mode when no center speaker is
connected. The center channel signals are output through the
left and right speakers.
3
CH LOGIC mode: Use this mode when no surround speakers
are connected. This mode reproduces rear sounds through the
front speakers.
To select PHANTOM or 3 CH LOGIC
Press the DOLBY PRO LOGIC button repeatedly until the desired
Dolby Pro Logic mode is displayed, The lDolby Pra Logic mocle
is displayed cyclically as follows.
1-
NORMAL - PHANTOM s 3 CH LOGIC –
~ cancel
—1
To adjust the balance of connected slpeaker sound levells
Carry out steps 2 to 4 on page 17.
● Depending on the sound source and/or listening conditions, a
surround effect may not be obtained even when the DOLBY
PRO LOGIC is on.
● The full DOLBY PRO LOGIC effect cannot be obtained when
using software without 0[1 IDOLBYSLIRROUNDImark. In this case, use
the SURROUND system instead. (See page 7.)
ENGLISH18