Operation Manual

MONO
TUNER
1 Press the TUNER/BAND button repeatedly to
select the desired band.
FM— AM
When the TUNEWBAND button is pressed while the power
is off, the power is turned on directly,
2 Press the l<+ DOWN
or F-1 UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, (iI@l}] is displayed.
To search for a station quickly (Auto Search)
Keep the PM DOWN or P>l UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the l<< DOWN or
➤>1
UP button.
● The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO button on the remote control so that “MONO”
appears on the display.
Noise is reduced, although reception is monaural,
MONO
To restore stereo reception, press the MONO TUNER button so
that MONO disappears,
To change the
AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is
9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
The unit can store a total of :32 preset stations. (Each band has
a maximum of 20 available Ipreset stations. ) When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1
2
3
Press the TUNER/BAND button to .sele(cta band,
and press the l++ [)OWN or E+! UP button tc~
select a station.
Press the 11 SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
lFrequency
I
Preset numbsr
Repeat steps f and 2!.
The next station will not be stored if a total of 32 preset stations
for all the bands or a total of 20 preset stations fm one bancl
have already been stored.
PRESET NUMBER “TUNING
Use the remote control to select the preset number directly.
7
Press the TUNER/BAND button to select a band.
2 Press the numberedl buttons to select a preset
number.
Example:
To select preset number 20, press the +1 O, +10 and Obuttons,
To select preset number 15, press the +1 O and 5 buttons.
Selecting a preset number on the main unit
Press the TUNER/BAND button to select a band, “Then, Ipress
the
● - DIRECTION/PRESl~T button repeatedly,
Each time the button is pressed, the next highest number is
selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the
■ CLEAR button, and press the II SET button within 4
seconds.
The preset numbers of all other stations in the bancl with higher
numbers are also decreased by one.
,EAfGL/!3H ~~