Operation Manual

3CH 4CH

CHANNEL

SETTING THE VIDEO CHANNEL ❑

If this unit is connected to the TV via the supplied antenna

cable, the video channel will have to be set.

The RF converter changes the video and audio signals played back from

the video ta~eto the same tv~e of sianals used for TV broadcasts. Set the

RF converter to VHF chan~el 3 or ~, not employed for broadcasts, with

the CHANNEL selector on the rear of the unit.

To receive audio/video output on the TV from this unit

Turn on both the TV and this unit. When your TV is connected only

through the antenna cable, select the video channel on the TV and select

the VCR mode by pressing the TVNCR button on the remote control,

When your TV is connected with an audio/video cable, select the video

input mode on the TV.

To receive a station broadcast from the TV set

Select the TV mode by pressing the TVNCR button, or turn the unit off.

When the unit is in the VCR mode, signals from the VCR are automatically

transmitted to the TV.

REMOTE CONTROL OPERATION

INSTALLING BATTERIES ❑

1 Open the battery compartment lid on the rear panel.

2 Insert two batteries (R6, size AA).

Make sure the batteries are inserted in the correct polarity as indicated.

3 Close the battery compartment lid.

Incorrect battery use may cause leakage or bursting. Observe the

following precautions:

● Insert the batteries in the correct polarity, as indicated on the unit,

● Do not mix new batteries with old ones.

. Do not use different kinds of batteries or those of different voltage.

● Remove the batteries when they are exhausted, or when the remote

control will not be used for a long period of time,

USING THE REMOTE CONTROL ❑

pOif7t the tWTIOte control toward the infrared REMOTE SENSOR on the

front of the VCR and press the buttons on it.

Hints for correct operation

●

For the remote control to operate, it should have an unobstructed line

of sight with the REMOTE SENSOR.

When there is a strong ambient light source, the performance of the

infrared REMOTE SENSOR is degraded, which may cause unreliable

operation.

The recommended effective distance for wireless operation is 7 meters

(23 feet). Operation can be performed at an angle of up to 30° from

either side, but the effective distance becomes somewhat shorter.

Using televisions with the same type of infrared remote control in the

same direction may cause the unit to operate incorrectly.