Operating instructions

POSITIONING THE SPEAKERS
Toachieve the optimumeffectsobtainable withthe DOLBY PRO
LOGIC system, it is importantto positionthe speakers properly.
Refer to the following illustrationto find out the best location in
your room.
6
CX-NMA845 ......
®
, J] (
O Front speakers
Center speaker
Positionthis at the center of the two front speakers and also,
if a'lV set is connected, on or below the set.
Surround speakers
Place the surround speakers directly to the side of or slightly
behind the listening area. Align them horizontally,about 1
meter (3.2 feet) above ear height.
• No sound is heard from the center and surround speakers when
the DOLBY PRO LOGIC, the SURROUND system and the 5.1
CH (page 31) are set to off.
• The center speaker sounds when the DOLBY PRO LOGIC or
the 5.1 CH (page 31) is set to on.
To mount the surround speakers on the wall
Mount each speaker on a spot that can hold its weioht.
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries,
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructionsinthis manual refer mainly to the buttons on the
main unit. Buttonson the remote control with the same names
as those on the main unit can be used as well.
I_/<11_ PRESET on the remote control
The function is the same as that of <11_ on the main unit.
-- I_/_11_ PRESET
• If the remote control is not go!ng to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)