Service manual

DISASSEMBLY INSTRUCTIONS
2-11: CYLINDER UNIT (Refer to Fig. 2-11)
Audio Control Head Base
Audio Control Head
Spring
Audio Control Head
Spring
Audio Control Head
1
1
Fig. 2-10
Plate Bottom
Deck Chassis
Mode Switch
Tension Lever
Spring
Capstan Belt
Position
Marker
2
Fig. 2-12
1
2
2
1
1
1.
2.
3.
Disconnect the following connectors: (CP4101 and
CP4102) on the Head Amp PCB.
Remove the Joint Screw, then remove the Azimuth Spring.
Remove the 2 screws 1, then remove the Polyslider
Washer and Cylinder Unit from the Main Chassis.
2-13: CENTER PULLEY (Refer to Fig. 2-13)
1. Remove the Polyslider Washer 1.
2. Remove the Center Pulley.
3. Remove the Polyslider Washer 2.
4. Remove the Center Pulley Spring.
5. Remove the Idler Arm Ass'y.
6. Remove the 2 Polyslider Washers 3.
7. Remove the Clutch Gear T Ass'y and Clutch Gear S Ass'y.
Clutch Gear T Ass'y
Idler Arm Ass'y
Center Pulley Spring
Center Pulley
Clutch Gear S Ass'y
Polyslider Washer 1
Fig. 2-13
Polyslider Washer 2
Polyslider Washer 3
Polyslider Washer 3
Main Chassis
Azimuth Spring
Joint Screw
Cylinder Unit
2-12: PLATE BOTTOM (Refer to Fig. 2-12)
1. Remove the Capstan Belt.
2. Remove the 2 screws 1.
3. Remove the 3 screws 2.
4. Remove the Mode Switch.
5. Remove the Tension Lever Spring.
6. Remove the Plate Bottom.
NOTE
When installing the Mode Switch, align the timing position.
1
1
Polyslider Washer
Fig. 2-11
B2-4