Operation Manual

14
En
Care and maintenance
Occasional care and maintenance of the unit and the software
are needed to optimize the performance of your unit.
To clean the cabinet
Use a soft and dry cloth. If the unit surfaces are extremely
dirty, use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as alcohol, benzene
or thinner.
Care of CDs
When a CD becomes dirty, wipe it from the center out with a
cleaning cloth. After playing a CD, store it in its case. Do not
keep it in hot or humid places.
Troubleshooting
If your unit fails to perform properly, check the following guide
and the relevant sections of this manual.
There is no sound
•Are the speakers and AC power cord connected properly?
The unit shut off suddenly
•Possibly a short circuit in the speaker terminals. Disconnect
the AC power cord from the AC outlet and reconnect the
speaker cords correctly.
All the display lights turn off when the power is off
•Is ECO mode set to on?
Erroneous display
•Reset the unit (see "Resetting the unit" on the next page).
REFERENCE
4 Push the dial left (f) or right (g) to set the
timer-on time.
5 Press function repeatedly to select the desired
playback source, then press enter/color or a.
6 Push the dial left (f) or right (g) to set the
timer-activated duration.
With each push, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
If there is no operation for 4 seconds, the current setting
is entered automatically.
7 Within 4 seconds, press enter/color or a.
The timer-on time and the source name with the timer-
activated duration are displayed once.
8 Adjust the volume and tone for timer playback.
If the volume level is set to 22 or higher, it is automatically
turned down to 21 when the unit is turned on by the timer.
9 Prepare the source.
To play CD, load a disc.
To play the radio, select the band and tune in the desired
station.
To play external equipment connected to the AUX IN jacks,
set an external timer for the equipment so that its playback
begins at the same time.
10 Press power 6 standby/on to turn the unit off.
"5" remains on the display to indicate timer standby
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•Timer playback will not begin unless the unit is turned off
first.
•Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.
To check the timer setting
1 Press sound/timer repeatedly to display "5 PLAY".
2 Within 7 seconds, press enter/color.
The timer-on time and the source name along with the timer-
activated duration appear alternately on the display.
3 Press enter/color or a twice to confirm the setting.
To change the timer setting
Reset the timer again.
To turn off the timer
1 Press sound/timer repeatedly to display "5 PLAY".
2 Within 7 seconds, push the dial left (f) or right
(g) so that "5 OFF" is displayed.
3 Within 7 seconds, press enter/color.
"5" disappears from the display.
Tip:
Your timer setting is retained even if the timer is turned off.
Next time the timer is turned on, you can change your previous
setting, or simply use the same setting again.