User guide

The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1 Press CLOCK/TIMER twice so that © appears
on the display, then press ENTER within 6
seconds.
© appears and the hour flashes.
0
SiilligiiiiBii
11
REitiA
If you press ENTER after 6 seconds, another operation may
start.
When using the remote control, press TIMER once so that
0 appears on the display, then press 11 SET within 6 seconds.
2 Designate the hour of the timer-on time by turning
MULTI JOG, then press ENTER.
Repeat to designate the minute of the timer-on
time.
After you designate the timer-on time, one of the source names
flashes on the display.
3 Turn MULTi JOG to select a source, then press
ENTER.
The source is displayed as follows.
->- TP TUN CD -H- VD MD -
(TAPE) (TUNER) (CD) (VIDEO) (MD)
' If TUNER is selected, the band cannot be selected in this
step.
4 Select the duration for the timer-activated period
with MULTi JOG, then press ENTER.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
5 Prepare the source.
To listen to a CD. load the CD to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press POWER on the stereo receiver to turn the
unit off after adjusting the volume and tone.
© remains on the display after the power is turned off (timer
standby mode).
iBiSlsPllili
Bitiirtiiii
©
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To check the specified time and source
Press CLOCK/TIMER twice (or TIMER once on the remote
control). The timer-on time, the selected source name and the
duration for the timer-activated period are displayed for 6
seconds.
To cancel timer standby mode temporarily
Press CLOCK/TIMER (or TIMER on the remote control)
repeatedly until © or ©REC disappears on the display.
To restore the timer standby mode, press CLOCK/TIMER (or
TIMER on the remote control) repeatedly to display ® or ©REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
' Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
I % A
1 8 ENGLISH